3Com Switch 4800G 24-Port Configuration Manual - page 19
1-14
packets timed out, and the IRF isolates the expired device in the topology and updates its topology
database.
When an IRF port of a member becomes down, the member broadcasts the information to all the other
members immediately. If the IRF port of the master is down, an election is triggered.
IRF Virtual Device Configuration Task List
Before configuring an IRF virtual device, you need to define the roles and functions of all the members
for better planning. Because the configuration of some parameters takes effect after device reboot, you
are recommended to first configure parameters, power off the devices, connect devices physically,
power on the devices, and finally the devices will join in the IRF virtual device automatically. After an
IRF virtual device is formed, you can configure and manage the IRF virtual device by logging in to any
device in the IRF virtual device. The operations you make take effect on the master, and will be applied
to the member devices in the IRF virtual device. For easy fault location and device maintenance, the
Switch 4800G series provide slave view, where you can execute the display, terminal, and debug
commands.
Complete the following tasks to configure IRF:
Task
Remarks
Configuring IRF Ports
Required
Setting a Member ID for a Device
Optional
Specifying a Priority for a Member Device
Required
Specifying the Preservation Time of the Bridge MAC
Address
Optional
Enabling Auto Upgrade of Boot Files
Optional
Configuring IRF Virtual
Device
Setting the Delay Time for the Link Layer to Report a
Link-Down Event
Optional
Connect the physical IRF ports of devices by using IRF cables (a ring connection is recommended) or fibers,
and then power on the devices.
Accessing the Master
Required
Accessing an IRF Virtual
Device
Accessing a Slave
Optional
Configuring IRF Virtual Device
Configuring IRF Ports
IRF ports are logical. IRF can be enabled on a device only after the IRF ports are configured (in other
words, the IRF ports are bound to physical IRF ports).
For how to bind the IRF port and physical IRF port(s) on a Switch 4800G series, see
Correspondence
between an IRF port and a physical IRF port
.
Follow these steps to configure IRF ports
To do…
Use the command…
Remarks
Enter system view
system-view —