3D Hobby Shop 33” Extra 330 SC Assembly Manual - page 21
SETUP
Congratulations! You have finished assembly of your 33” Extra 330 SC. Now it’s time for Setup.
At this time, you can setup your control throws, exponential and center of gravity.
Please refer to the recommended setup sheet at the end of the manual for our setup recommendation.
Once you have determined where your battery must be located to obtain the correct Center of Gravity,
install your preferred method of mounting the battery. We recommend using a strip of Velcro and
adhering it to the side of the fuselage with Welders Adhesive.
Finally, You will want to install the propeller recommended for your motor.
We have provided a small length of tubing that you can cut up and use for a prop-band mounting system.
Step F-01: Completion
Before Flying your 33” Extra 330 SC for the First Time
Before flying your foamy for the first time, we recommend that you run through the following checklist.
We’re sure you’re anxious to get out and fly your new foamy, but please note that following this checklist
will ensure that you have the best experience possible with your 33” EPP Extra 330 SC.
1.) Check for secure control linkages. Make sure that all of the Z-Bends are secure, and that all of the
control horns are secured in place and the glue has fully cured.
2.) Range Check. Please perform a range check to ensure that your radio and receiver system are
functioning correctly
3.) Radio Setup Check. Please perform a simple ground check to make sure that all control surfaces
are moving in the correct direction, and that no switches on your radio do something you don’t expect.
Now would be a good time to CAREFULLY ensure that your propeller is spinning the right direction.
4.) Charge up a few batteries, and have a safe, enjoyable maiden flight!
Step F-02: Checklist