3D Systems Cube 3rd Generation Quick Start Manual - page 6

3

UNPACK YOUR CUBE

NOTE: Keep all packing materials for future transport. Shipping the printer without 

the original packing materials may damage the printer and void the manufacturer’s 

warranty.

1. 

Pull the clips (A) and remove them from the top of the 

printer box and open the box.

2. 

Remove the upper foam support.

3. 

Remove the printer from the box and remove the 

protective bag from the printer. Place the printer on a 

solid, level base.

NOTE: When installing the printer there must 

be a minimum of 8” (203 mm) of space on top 

and on either side of the printer.

NOTE: There must be a minimum of 4” (102 

mm) space in front of and behind the printer.

A