3D Systems CUBE Quick Start Manual - page 27
Manual is about: Personal 3D Printer 3rd Generation
of
32
24
MAINTENANCE
PRINT PAD MAINTENANCE
Auto Level and Auto Gap can be affected by a residual glue or print material adhered to the print pad.
These procedures can also be affected by a print pad that is too shiny.
1.
Select
PLATE MAINTENANCE
.
2.
Remove the print pad.
NOTE: The print pad is magnetically attached to
the adjustment knobs.
3.
Using the fine-grit sandpaper, buff the print pad.
NOTE: Refer to the section titled Clean The Print
Pad for specific instructions.
NOTE: Ensure the print pad is clean and dry
before installing it in the printer.
4.
Select the
checkmark
to continue.
5.
Perform the Auto Level and Auto Gap procedures.