3D Systems CubePro Original Instructions Manual - page 11

Leveling The Print Jet Nozzles

Tools Needed

• 

T10 Torx Driver

Level The Print Jets

SHOCK WARNING: EXERCISE CAUTION WHENEVER YOU ARE NEAR ELECTRICAL COMPONENTS .

WARNING:  BEFORE SERVICING THESE COMPONENTS, ENSURE YOU ARE WEARING A WELL-GROUNDED 

ELECTRO-STATIC DISCHARGE (ESD) STRAP . ESD PROTECTION IS REQUIRED .

WARNING: NEVER PULL ON WIRES TO DISCONNECT THE CONNECTORS . THIS COULD DAMAGE THE 

WIRES AND THE CONNECTORS AND VOID THE MANUFACTURER’S WARRANTY.

The following procedure is intended to provide instructions about how to level print jets for printers with more than 1 print jet .

1 .  For printers with two (2) or three (3) print jets, loosen the T10 torx screws on 

extruders 1 and 3 . 

CAUTION: There should be enough access to reach the torx 

screws using an insulated torx driver . Exercise caution when 

working around the PCBs .

NOTE: Print jet 2 should not need adjustments .

2 .  Connect the printer to utility power, turn on the main power switch and then turn 

on the display .

3 .  Navigate to the 

Print Plate Calibration

 screen and select 

MOVE JETS

 .

4 .  Select the Z: down arrow until the display reads -0 .50 .

NOTE: For printers with 2 or three print jets, visually inspect 

the gap between the nozzle tip of print jet 2 and the print pad . If 

necessary, press the Z: down arrow until there is a gap .