3D Systems CubePro Original Instructions Manual - page 3

1

   INTRODUCTION 

COPYRIGHT

© 2016 by 3D Systems, Inc . All rights reserved . This document is subject to change without notice . This document is copyrighted and 

contains proprietary information that is the property of 3D Systems, Inc . Cubify, and the 3D Systems logo are registered trademarks 

of 3D Systems, Inc . CubePro is a trademark of 3D Systems, Inc . Use of the Cubify .com website constitutes acceptance of its Terms of 

Service and Privacy Policy .

FCC NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules . 

These limits are designed to provide reasonable protection against harmful interference in a residential installation . This equipment 

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications . However, there is no guarantee that interference will not occur in a particular installation . 

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna .

—Increase the separation between the equipment and receiver .

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help .

NOTE: Changes or modifications to this equipment not specifically approved by 3D Systems may void the user’s 

authority to operate this equipment.

KCC

이 기기는 가정용(B급) 전자파적합기기로서 주 로 가정에서 사용하는 것을 목적으로 하며, 모 든 지역에서 사용할 수 있습니다.

This equipment is home use (Class B) electromagnetic wave suitability equipment and to be used mainly at home and it can be used in 

all areas .

COMPLIANCE

This equipment conforms with International Electric Committee (IEC) 60950-1 and meets the requirements of the applicable EC 

directives . 

CAN ICES-3 (B)/NMB-3(B)

This device complies with Industry Canada license-exempt RSS standard(s) . Operation is subject to the following two conditions: 

(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause 

undesired operation of the device .

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence . L’exploitation est 

autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter 

tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement .

WARRANTY

3D Systems warrants that the CubePro 3D Printer will be free from defects in materials and workmanship, during the applicable 

warranty period, when used under the normal conditions described in the documentation provided to you, including this User Guide . 3D 

Systems will promptly repair or replace the CubePro 3D Printer, if required, to make it free of defects during the warranty period . This 

warranty excludes (i) normal consumable or expendable parts (such as Material Cartridges), (ii) repairs required during the warranty 

period because of abnormal use or conditions (such as riots, floods, misuse, neglect or improper service by anyone except 3D Systems 

or its authorized service provider), and (iii) repairs required during the warranty period because of the use of non-integrated, non-

approved or non-licensed materials with the CubePro 3D Printer . The warranty period for the CubePro 3D printer is the shorter of (i) 

90 days from the date your CubePro 3D printer is activated or (ii) 24 months after the CubePro 3D Printer is shipped from 3D Systems 

to the end customer or intermediary . For consumers who are covered by consumer protection laws or regulations in their country of 

purchase or, if different, their country of residence, the benefits conferred by our ninety (90) day warranty are in addition to, and operate 

concurrently with, all rights and remedies conveyed by such consumer protection laws and regulations, including but not limited to these 

additional rights .