3D Systems ProX 800 Original Instructions Manual - page 16
3D Systems, Inc.
13
Support equipment which includes, but is not limited to:
•
Part cleaning and finishing equipment - this may be a very simple system, or more complex, depending on your
needs and space . Minimally, two covered tubs are needed to accommodate ProX 800 print pads so that the parts
may be washed and rinsed after building .
•
Sink(s) .
•
Resin storage cabinet .
•
Workbench—for processing parts and removing supports—“green” area and clean area with down-draft table for
sanding .
•
Any desired post-processing equipment—to sand, join, grind, polish, paint or plate SLA parts .
•
Compressed air connection with pressure controller and fast-closing connection for part finishing, if desired.
Recommended safety equipment and supplies:
•
Fire extinguishers .
Use National Fire Protection Association Class B extinguishers such as carbon dioxide, dry chemical, or
foam .
•
Smoke alarm in room .
•
Eyewash stations .
•
Protective clothing, including chemical-resistant nitrile gloves and lab coats with long sleeves .
•
Safety eye glasses with side shields and UV coating .
•
Hazardous waste cans for chemicals