3D Systems ProX 800 User Manual - page 60

3D Systems, Inc.

60

INSTALLATION OF PRINT PLATFORM WITHOUT OFFLOAD CART

Verify that the MDM is installed in the printer before starting this process. Wear nitrile gloves when handling the print pad to 

prevent material exposure to your skin.

1

2

Print Pad inside Print Chamber 

(MDM not shown for clarity, but should be installed)

L-Shaped Guides

Front print pad notched guides

1.  Verify that the elevator is at its offload position. If necessary, move it to its offload position by selecting 

the 

Move to Offload

 button on the 

Elevator/Leveler

 screen under the 

Tools

 menu.

2.  Place the print pad between the 

L-shaped guides 

(1) towards the rear of the print chamber.

3.  Pull the print pad forward against the 

print pad notched guides

 at the front (2).

4.  Make sure that the front edge of the print pad engages with the notched print pad guides.

5.  Move the elevator to the Start position by pressing 

Move to Start 

on the 

Elevator/Leveler

 screen under the 

Tools

 menu.

Elevator 

Platform

Print Pad

NOTE: If this is right after a build, you may get the warning message, “Print applicator is not 

at home position .” If so, press 

Print Applicator > Move to Home .

NOTE: While starting a print job will automatically move the build platform home, it is best 

to manually home the elevator after installing to prevent bubbles and other defects in the 

vat resin .