3DISON H700 User Manual - page 18
35
34
3DISON H700 User Manual V.1
3DISON H700 User Manual V.1
Laser Engraver
③
Import worked .stl file after execute CreatorK 8
and click G-code generating button on the top.
④
Select Laser Mode in Printing Option and click
Generate Gcode.
⑤
Transfer the generated Gcode to another Gcode
optimized to use the laser function by clicking
Laser Icon.
⑥
Save the generated Gcode for laser use in the
format of x3g in SD Card. Then directly insert it in
the printer and turn on the printer.
NOTE : Go to Utilities < Laser Blinking to check if
laser works properly or not. This blinking lasts for 5
seconds.
NOTE : Before using the laser engraver, make sure
that ‘Standard Leveling’ has been completed.
(refer to page 13)
Annex2. Extra Features
(Laser Engraver / WiFi Camera / Embedded Battery)
WiFi Camera
ItisnownowmoreconvenienttocheckontheprintingprogresswiththeWificamera.You
canpromptlytakeactiontosolveanykindoftroubleusingsmartphoneapplication(VSCam).
FollowingistheinstructiononhowtoutilizeWiFiCameramonitoringthroughyourmobile
orcomputer.
④
Click an added camera to set IPCAM for wireless
connect-ion.
[Camera settings] > [WIFI settings] > [WIFI Man-
ager] > select a currently used wireless SSID > fin-
ish by inputting PIN.
③
Enter [Add Camera] after execution of ‘VsCam
app’ to input UID number attached to a rear surface
of body, and input an initial PIN (personal identifica-
tion number) 888888.
②
Download “VsCam” app using a mobile phone.
(Android and IOS are supportable)
①
Connect the Internet router to WIFI Camera via
LAN cable. About one minute of booting time is
required.
Annex2. Extra Features
(Laser Engraver / WiFi Camera / Embedded Battery)
1. Connecting to your mobile