3DR Solo S110A User Manual - page 22
of
70
17
3.2.3
Position Cables
With both cables now connected to the Solo Gimbal, it is important to position each cable out of the way of other
internal components. When configuring the HDMI and gimbal cables, the HDMI cable should rest on top of the
gimbal cable.
1. Position the gimbal cable out out of the way by pushing any slack towards the front of the Solo Shell.
Tuck the Gimbal Cable’s slack
into the front of the Solo body
Figure 3.2.3.1: Positioning the Gimbal Cable
2. Loop the HDMI cable around and inside the front of the body, pushing any extra slack towards the pocket of
Arm #01 as seen below.
Tuck the HDMI Cable’s slack
into the side of the Solo body
Figure 3.2.3.2: Positioning the HDMI Cable