Pag. 1 instruction manual bse-150 english active indoor and outdoor active indoor and outdoor active indoor and outdoor infrared barrier with infrared barrier with infrared barrier with 3 beams of protection 3 beams of protection 3 beams of protection installation installation installation manual ma...
Pag. 2 manuale istruzioni bse-150 english 1 - product discription the bse-150 is an active indoor & outdoor infrared detector with 3 beams of protection. It has regulations for : vertical axial from (+10° to –10°), horizontal axial from (+90° to –90°), and for the trigger response time from 1 to 5 (...
Pag. 3 instruction manual bse-150 english avoid mounting the unit on columns that my not be stable. Avoid mounting the unit in direct sun light or high luminosity light sources. Outdoor installations: due not install the bst-100 where animals, trees, bushes or other plants can interrupt the line of ...
Pag. 4 manuale istruzioni bse-150 english 3.1.1 remove front cover 3.1.2 using the metal base, mark on the wall the position of the fixing holes. See below: 3.1.3 insert the connection cable that comes from the control panel. 3.1.4 fix to the wall the metal base of the sensor. ● installation on colu...
Pag. 5 instruction manual bse-150 english replace the front cover and test if the active infrared barrier is functio- ning correctly. If not,it must be recalibrated. Note: the more precise is the alignment, the more intense will be the luminosity of the red led. It is best to regulate the sensor unt...
Pag. 6 manuale istruzioni bse-150 english 6 - dimension 2 7 0 m m 2 3 0 m m 89mm support column 3- 8 55 mm 95mm fixing holes 2 x 4,5mm material for fixing to support column 5 - regulation of trigger responce 1 run (6,9m/sec.) 2 fast walk (1,2m/s) 3 normal walk (0,7m/s) 4 slow movement (0,3-0,5m/s) 5...
Pag. 7 instruction manual bse-150 english problem cause solution the indicator leds of transmit- tor and receiver do not light 12 vdc. Not present or defective power source present. The alarm led does not light and the alarm trigger relay does not change state if both beams are interupted. 1- check ...
Pag. 8 manuale istruzioni bse-150 italiano italiano tre i systems is not responsable for inappropriate use or installation of the products manufactured. For any problems contact the nearest authorized tre i systems sales office or service center. Tre i systems reserves the right to change or make im...
