3M DBI SALA 8518579 User Instruction Manual - 7.0 Specifications
18
Lube hole
in center
of primary
drive hub
6.2 LUBRICATION
OF
DIGITAL WINCH
BRAKE PADS: A light
lubricant such as WD-40
should be sprayed into
the brake pad lubrication
holes every fi ve to eight
uses of the winch. Two
lube holes are located
along the back of the
housing. A label marks
their location. A third lube hole can be found at the center of the
primary drive hub, in the middle of the brake pad wear indicator
(see Figure 13).
6.3
Replacement parts, as well as additional maintenance and
servicing procedures, must be completed by a factory authorized
service center. An authorization and a return number must be
issued by DBI-SALA.
6.4
Store this equipment in a cool, dry, clean environment out of direct
sunlight. Avoid areas where chemical vapors exist. Inspect after
any period of extended storage.
6.5 Clean and store body support, support structure, and associated
system components according to separate instructions provided
with that equipment.
7.0 SPECIFICATIONS
7.1 MATERIALS:
Housing: Cast Aluminum with powder coat paint fi nish.
Lifeline:
•3/16 in. (5 mm) Stainless Steel
•1/4 in. (6 mm) Stainless Steel
•3/8 in. (10 mm) Stainless Steel
•5/8 in. (16 mm) Stainless Steel
•3/16 in. (5 mm) Non-rotating Stainless Steel
•3/16 in. (5 mm) Galvanized Steel
•3/16 in. (5 mm) Technora Cord
•1/4 in. (6 mm) Technora Rope
•5/16 in. (8 mm) Kernmantle Rope
•3/8 in. (10 mm) Kernmantle Rope
•1/2 in. (12 mm) Kernmantle Rope
•5/8 in. (16 mm) Kernmantle Rope
Figure 13 - Brake Pad Lube Hole
netzerotools.com
netzerotools.com