3M MicroTouch Near Field Imaging (NFI) Integration Manual - page 38
MicroTouch
TM
Near Field Imaging (NFI)
TM
Integration Guide
3M Touch Systems Proprietary Information
32
FCC compliance note
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules and ICES 03. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Electromagnetic compatibility immunity standards
Tests were successfully conducted on a sample of the equipment for the purpose
of demonstrating EMI compliance with EN 61000-6-2 Generic Industrial
Immunity Standard and EN 55024 Information Technology Immunity Standard.
Certifications
Standard
Test
Electrostatic discharge
EN 61000-4-2
Radiated immunity, modulated
EN 61000-4-3
Radiated immunity, keyed carrier
ENV 50204
Electrical fast transient/burst
EN 61000-4-4
Surge transient
EN 61000-4-5
Conducted immunity
EN 61000-4-6
Power frequency magnetic field
EN 61000-4-8
Voltage dips and interruptions
EN 61000-4-11
UL Recognized component (File E 217706).
CE Information Technology Equipment — Europe
The NFI touch screen system has been tested to the following standards to show
compatibility for use in products requiring CE marking under the following directives:
EMC Directive 89/336/EEC
Low Voltage Directive 73/23/EEC
Machinery Directive 89/392/EEC