3M MINI RANDOM ORBITAL SANDER Instruction Manual
3M™ 1 1/4 in Mini Random Orbital Sander
1
Revision 040610
Parts Page
Intended Use
MINI RANDOM ORBITAL SANDER
INSTRUCTION MANUAL
32 mm (1 1/4 in) 8,000 RPM
Important Safety Information
Please read, understand and follow all safety information contained in these instructions prior to the use of this tool. Retain these
instructions for future reference.
This pneumatic tool is intended for use in industrial locations, and used only by skilled, trained professionals in accordance with the
instructions in this manual. This pneumatic tool is designed to be used with a disc pad and appropriate abrasive for sanding metals,
wood, stone, plastics and other materials. It should only be used for such sanding applications and within marked capacity and ratings.
Only accessories specifically recommended by 3M should be used with this tool. Use in any other manner or with other accessories
could lead to unsafe operating conditions.
Damp application using water or water-solvent mixture is acceptable, but only when care is exercised to avoid injury due to splashing of
liquid. Also, careful cleaning of tool is necessary following each use of tool in damp application.
Do not use disc pads that have a Max RPM or Max OPM less than the tool Max RPM or Max OPM rating. Never use disc pads that have
a weight and/or size different than what the tool was specifically designed for.
To reduce the risks associated with impact from abrasive product, disc pad, or tool breakup, sharp edges, hazardous
pressure, rupture, vibration and noise:
• Read, understand and follow the safety information contained in these instructions prior to the use of this tool. Retain these
instructions for future reference.
• Only personnel who are properly trained should be allowed to service this tool.
• Practice safety requirements. Work alert, have proper attire, and do not operate tools under the influence of alcohol or drugs.
• Operators and other personnel must always wear protection for eyes, ears, and respiratory protection when in the work area or
while operating this product. Follow your employer’s safety policy for PPE’s and/or ANSI Z87.1 or local/national standards for
eyewear and other personal protective equipment requirements.
• Wear protective apparel, taking into consideration the type of work being done.
• Never exceed marked maximum input pressure (90psi / .62Mpa / 6.2Bars).
• Proper eye protection must be worn at all times.
• Tool shall not be operated in the presence of bystanders.
• If you notice any abnormal noise or vibration when operating the tool, immediately discontinue its use and inspect for worn or
damaged components. Correct or replace the suspect component. If abnormal noise or vibration still exists, return the tool to 3M
for repair or replacement. Refer to warranty instructions.
• Never operate this tool without all safety features in place and in proper working order.
• Never over-ride or disable the safety features of the start-stop control such that it is in the on position.
• Make sure the tool is disconnected from its air source before servicing, inspecting, maintaining, cleaning, and before changing
abrasive product.
• Prior to use, inspect abrasive product and accessories for possible damage. If damaged, replace with new abrasive product and
accessories available from 3M.
• Only use accessories supplied or recommended by 3M.
• Never allow this tool to be used by children or other untrained people.
• Do not leave an unattended tool connected to air source.
• Immediately discontinue use of tool if its noise reduction muffler system has been damaged or is otherwise not functioning
properly. Have tool repaired before placing back into use.
Explanation of Signal Word Consequences
Indicates a potentially hazardous situation which, if not avoided, may result in death or serious injury
and/or property damage.
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate
injury and/or property damage.
WARNING:
CAUTION:
Original Instructions
WARNING