3M Wall Display Quick Start Manual
SHUTDOWN
STARTUP
1
2
3
Make sure the Master Power
Switch is On. It is located underneath
the Wall Display on the right side of
the power cord. (Leave this switch On.)
The On/Off button will turn amber in
approximately 5 seconds.
Plug power
cord into
outlet.
Press the
On/Off button.
• After pressing, the On/Off button blinks green, then stays green.
• The projection arm extends out from the top of Wall Display.
• The fan motor starts.
• The lamp comes on. (Allow approximately 1 minute for full illumination.)
WA
LL
D
IS
PL
AY
Q
UI
CK
S
TA
RT
G
UI
DE
2
00:05:00
00:00:00
The On/Off button blinks
red for 30 seconds. The
projection arm closes. The
fan runs for 5 minutes.
“Wherever there's a great meeting, you’ll find 3M.”
™
www.3M.com/walldisplay
Innovation
Note: After the On/Off button
is pressed, the unit will not
respond to any other commands
for 30 seconds.
fold
1
(Leave the Master Power Switch turned On.)
Press the On/Off button.
Q
U
I
C
K
S
T
A
R
T
G
U
I
D
E
W A L L D I S P L A Y Q U I C K S T A R T G U I D E
W A L L D I S P L A Y Q U I C K S T A R T G U I D E
7 8 - 6 9 7 0 - 9 0 7 5 - 7
P a g e 1 o f 2