3M X95I - Digital Projector XGA LCD Product Warranty And Safety Manual - Warning
3M™ Digital Projector X95i Product Warranty and Safety Guide
16
ENGLISH
© 3M 2009. All rights reserved.
Consumption of the battery makes the clock not to work correctly. When the clock is wrong or it
has stopped, please replace the battery according to the following procedures.
1. Turn the projector off, and unplug the power cord. Allow the
SURMHFWRUWRFRROVXI¿FLHQWO\
2. After making sure that the projector has cooled adequately,
slowly turn over the projector, so that the bottom is facing.
3. Turn the battery cover fully in the direction indicated “OPEN”
using a coin or the like, and pick the cover up to remove it.
4. One of two kinds of clock battery holder, A or B shown to the
right, is inside the battery cover.
For A holder:
3U\XSWKHEDWWHU\XVLQJDÀDWKHDGVFUHZGULYHURUWKHOLNHWRWDNHLWRXW
:KLOHSU\LQJLWXSSXWD¿QJHUOLJKWO\RQWKHEDWWHU\VLQFHLWPD\SRS
out of the holder.
For B holder:
3UHVVWKHPHWDOFODZRIWKHEDWWHU\KROGHUSXWWLQJD¿QJHUOLJKWO\
on the battery since it may pop out of the holder. Then the battery
will come up. Remove the battery.
5. Replace the battery with a newHITACHI MAXELLL, Part
No. CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push it into the
holder until it clicks.
6. Replace the battery cover in place, then turn it in the direction
indicated “CLOSE
´XVLQJVXFKDVFRLQVWR¿[
Replacing the internal clock battery
WARNING
Always handle the batteries with care and use them only as directed. Battery may
H[SORGHLIPLVWUHDWHG'RQRWUHFKDUJHGLVDVVHPEOHRUGLVSRVHRILQ¿UH$QGDOVR
LPSURSHUXVHPD\UHVXOWLQFUDFNLQJRUOHDNDJHZKLFKFRXOGUHVXOWLQ¿UHLQMXU\DQG
or pollution of the surrounding environment.:
-
%HVXUHWRXVHRQO\WKHEDWWHULHVVSHFL¿HG
-
Make sure the plus and minus terminals are correctly aligned when loading a battery.
-
Keep a battery away from children and pets. If swallowed consult a physician
immediately for emergency treatment.
-
Do not short circuit or solder a battery.
-
'RQRWDOORZDEDWWHU\LQD¿UHRUZDWHU.HHSEDWWHULHVLQDGDUNFRRODQGGU\SODFH
-
If you observe battery leakage, wipe out the leakage and then replace a battery. If the
leakage adheres to your body or clothes, rinse well with water immediately.
-
Obey the local laws on disposing the battery.
¥Note
,IWKHEDWWHU\LVLQVHUWHGXSVLGHGRZQLQWKH%KROGHULWPLJKWEHGLI¿FXOWWRUHPRYH,IWKDW
KDSSHQVWDNHIROORZLQJPHDVXUHV
1. Remove the battery cover and turn the projector’s upside up.
2. While lifting the side of the projector closer to the lens, press the metal claw of the battery holder.
The battery will fall out of the holder, so be careful not to lose it.
Battery Cover
OPEN
CLOS
E
OPEN
CLOS
E
OPEN
CLOS
E
OPEN
CLOS
E
OPEN
CLOSE
90°
OPEN
CLOSE
90°