4RF Aprisa LE Quick Start Manual
Quick Start Guide
Contents
Follow these steps to install and access your Aprisa LE radio link:
1. Check the box contents
2. Verify you have all the required tools
3. Install the radio terminals
4. Apply power to the radio terminals
5. Access the radio terminals via Ethernet
5. Access the radio terminals via Ethernet
1. Confirm that your PC has the following software installed:
•
Java VM
•
Mozilla Firefox, or Microsoft Internet Explorer web browser
If necessary, install this software from the CD supplied.
IMPORTANT
In order to communicate via Ethernet, each piece of equipment must have compatible IP
addresses on the same subnet. The radio terminals are pre-configured with one of the IP
addresses and the subnet shown below.
To connect to the radio terminal, set the subnet mask on your PC to 255.255.0.0 and select a
compatible IP address e.g. 169.254.50.1.
To setup the IP addresses on your PC, open the Windows Control Panel > Network
Connections and right click on your Local Area Connection (primary network
connection).
Select Properties > Internet Protocol (TCP/IP) and click Properties.
In the Internet Protocol (TCP/IP) Properties window, set up your PC IP address and
Subnet mask as shown below.
2. Using the Ethernet cable, connect the PC’s Ethernet port to one of the radio
terminal’s Ethernet ports.
3. Start your web browser and in the address field, enter the radio terminals IP
address.
The following screen should open from which you can login to the radio terminal.
You are now ready to start configuring your radio link.
Please refer to the Aprisa LE User Manual (supplied on the CD) for details on how to
change settings and optomise the performance of your Aprisa LE link.
If the above screen does not open, refer to the Aprisa LE User Manual and follow
the steps in the ‘Managing the Terminal’ section titled ‘Changing the Terminal’s IP
Address’.
Aprisa LE Quick Start Guide 1.1.1 © 2012 4RF Limited. All rights reserved. This document is protected by copyright belonging to 4RF Limited and may not be reproduced or republished in whole or part in any form without the prior written
permission of 4RF Limited. While every precaution has been taken in the preparation of this literature, 4RF Limited assumes no liability or errors and omissions, or from any damages resulting from use of this information. The contents and any
product specifications within it are subject to revision due to ongoing product improvements and may change without notice. Aprisa and the 4RF logo are trademarks of 4RF Limited. All other marks are the property of their respective owners.