4RF Aprisa LE Quick Start Manual - page 2
1. Check the box contents
3. Install the radio terminals
2. Verify you have the required tools
4. Apply power to the radio terminals
Each Aprisa LE radio is shipped to you in a single box containing the following items:
Aprisa LE Radio [x1]
Information and setup CD [x1] including the following:
•
Radio Terminal software
•
Mozilla Firefox web browser
•
Microsoft® Internet Explorer web browser
•
4RF Surveyor path propagation calculator
•
Java™ VM software
•
TFTP server software
•
Aprisa LE Datasheet, Product Description and User Manual
•
Brochures, Case Studies, White Papers, Software Release Notes
•
Adobe® Reader® software (for viewing the PDF files on the CD)
Configuration Sheet [x1]
Commissioning Form [x1]
You will need the following additional equipment:
Personal computer (PC) with the following minimum requirements:
•
800 MHz Intel® Pentium III processor
•
200 MB of free hard disk space
•
CD ROM drive
•
Either a COM port or USB port (with the DB-9 serial to USB adaptor)
•
Ethernet interface
•
Microsoft Windows® 2000, XP or later
•
Java™ VM software v1.6 or later
•
Microsoft® Internet Explorer or Mozilla Firefox web browser
• Rack mount bracket [x2]
Accessory kit [x1] containing the following:
• Bracket fastening screw [x4]
(countersink PZD2)
• M6 caged nut [x4]
• Nylon washer [x6]
• M6 x 8 (PZD3) [x6]
• M2 Allen key [x1]
(for fascia and lid screws)
• 100 mm cable tie [x20]
• Setup cable with
RJ-45 to DB-9 adaptor [x1]
• Power cable [x1]
12 VDC, 24/48 VDC or AC
• Ethernet cable spare [x1]
A pozidrive screwdriver (PZD2)
A pozidrive screwdriver (PZD3)
A Philips (size 2) OR flat-blade screwdriver (5 mm))
An 8 mm spanner
A DB-9 serial to USB adaptor
This adaptor will only be required if you wish to connect to the Aprisa LE
SETUP port and the PC does not have a serial COM port (DB-9).
3. Confirm that your antenna, feeder cable, weatherproofing, earthing and
lightning protection are correctly installed.
1. Fasten the mounting brackets to the radio terminal and mount it in the rack
2. Connect the radio terminal’s earth stud to the rack with the Earth cable using
the 8 mm spanner
4. Connect the flexible coaxial jumper cable between the lightning protector and
radio antenna connector.
1. Connect the external power supply to the radio terminal using the terminated power cable as illustrated below.
2. For DC power supplies, switch on the external power supply.
For AC power supplies, turn the radio power switch on.