5th-room 5RBWS2 User Manual - page 8
P.
DISTORTED
-
Press the “AUTO TUNE” button on the speakers until it matches the
frequency of the transmitter.
-
Change the position of the channel selector on the transmitter. You must
then press the “AUTO TUNE” button on the speakers.
-
Battery capacity is too low. Replace with new batteries.
-
Ensure the volume level of speakers is adjusted properly.
-
The speaker is too far from transmitter, move closer.
-
The input level of the audio signal is too low. Turn up the volume of the
audio source equipment.
TECHNICAL SPECIFICATIONS
Transmission Mode
:
UHF stereo
Carrier Frequency
:
900 MHz
Operation Voltage
:
Transmitter, DC 6V 300mA
Speaker, 8 X “C” size Alkaline batteries
(included) or DC 12V 750mA adaptor
Remote Control Unit, 2 X ‘AAA’ size batteries
(included)
Frequency Response
:
40Hz – 12KHz
Distortion :
1.5%
S/N Ratio
:
65dB (typical)
Channel Separation
:
35dB (typical)
Operating Distance
:
Up to 50 metres (150 feet)
Output Power
:
2 x 5W (Max)
WARNING:
This device complies with AS/NZS CISPR 13:2004 and AS/AZS
22:2006 Australian Standards Tests.
This is a Class A Product
This device may cause radio interference in some situations in
which case the user is required to take adequate measures when
operating this device