909 RL3003 Instruction Manual - page 9
9
Never submerge the unit in water. If the unit gets dirty,
gently clean the outer surfaces of the spotlight unit with
a soft cloth moistened with a mild solution of water and
detergent.
Except for the 12V/100W bulb, there are no user-
replaceable parts. Periodically inspect the condition of
adapters, connectors and wires. Contact manufacturer to
replace any components that have become worn or broken.
Battery replacement/disposal
Battery replacement
The battery should last the service life of the unit. Contact
manufacturer for any information you may need.
Safe battery disposal
Contains a maintenance-free, sealed, non-spillable, lead
acid battery, which must be disposed of properly. Recycling
is required, contact your local authority for information.
WARNINGS:
•
Do not dispose of the battery in fire as this may result in
an explosion.
•
Before disposing of the battery, protect exposed terminals
with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire).
•
Do not expose battery to fire or intense heat as it may
explode.
Spotlight bulb replacement (diagram follows)
To replace the bulb, you will need a small Phillips
screwdriver and a 12V/100Watt replacement bulb. During
installation, avoid touching the glass part of the bulb.
Bulb life may be shortened by installing a bulb with dirt or
fingerprints on it. The bulb can be wiped clean with a cloth
moistened with alcohol.
Rubber Bezel
Use a screwdriver to
gently pry the rubber
bezel off.
Retaining
Ring
Glass
Lens
Rubber
“O” Ring
Light
Reflector
Phillips
Screw
On/Off
Trigger
Phillips Screw
Halogen Bulb Assembly
Only replace the bulb in an
interated assembly of lamp
holder, wire and tab.
Retaining
Screw
Light
Reflector
Hairpin
Retaining
Wire
Halogen
Bulb
Assembly