A&D SW-D Setup Instructions - page 19
17
8.2. Setting unit for use
1. Refer to “7.1. Items of the calibration”, to enter the
calibration mode. The indicator displays “
Cal5et
”.
2. Press the
MODE key three times to display “
Cf
”.
3. Press the
TARE key to display the setting item.
4. To proceed without storing this setting item, press the
ZERO key.
After displaying “
Unit
”, proceed to the unit setting mode.
(Display example: “
1110000
pcs”)
5. Select the unit to be used, using the following keys.
UNITS Select the unit (Shift the blinking unit to the
right)
PRINT Set whether the selected unit is available (0)
or not available (1). (Change the number of the
blinking digit to “0” or “1”.)
About the unit setting mode
Each of the display digits are assigned to a unit setting.
(The setting at the first and fourth digit is not available.)
Display
assignment
7 6 5 4 3 2 1
Unit pcs
g
kg
Set
disabled
oz lb
Set
disabled
-The unit during selection is indicated.
-With each digit, if setting to “0”, its unit is not available, and
if setting to “1”, its unit is available.
(Only when set to “1”, is a unit available.)
Even if a unit is stored, availability for use depends on the
weighing capacity and resolution.
Example) When setting to “
1010000
pcs”, only “pcs”
and ”kg” are available as units.
6. Press the
TARE key to store the setting. After displaying
“
end
”, the indicator displays “
Cf
”, and the setting is complete.
If you want to proceed without storing the setting of the unit
setting mode, press the
ZERO key. After displaying “
Cf
”,
the setting is complete.
Press
Press
Press
Press
Press
three times