A&D TM-2657P Instruction Manual - Setting The Clock
15
8.
SETTING THE CLOCK
To set the date and time, use the clock setting mode. The clock setting mode has the following
display.
Setting the date and time:
Use the following buttons.
SELECT button: 1. While the monitor is in the standby mode, hold the SELECT button for 1
second to enter the clock setting mode. The year value will start flashing.
2. Press the
SELECT button to select the date or time value to be set.
Each time the
SELECT button is pressed, the flashing value changes from
year, month, day, hour, minute, and then back to year. The selected item
flashes and can be changed.
▲ button:
Change the selected (flashing) values.
START/STOP button: Once the desired date and time is selected, press the START/STOP button
to save the changes and return to the standby mode.
COUNT button:
If the
COUNT button is pressed while performing settings, changes are not
saved and the monitor returns to the standby mode.
Setting example: Set to 4:37 PM, April 20, 2015
1. Hold the
SELECT button for 1 second. The systolic display section starts flashing.
2. Press the ▲ button to display 15. (2015)
3. Press the
SELECT button. The diastolic display section starts flashing.
4. Press the ▲ button to display 4. (April)
5. Press the
SELECT button. The pulse display section starts flashing.
6. Press the ▲ button to display 20. (20th)
7. Press the
SELECT button to select the hour on the clock display. The hour setting starts
flashing.
8. Press the ▲ button to display 16. (4 PM)
9. Press the
SELECT button to select the minute on the clock display. The minute setting starts
flashing.
10. Press the ▲ button to display 37. (37 minutes)
11. Press the
START/STOP button to return to the standby mode.
Notes
If no operation is performed for about 10 seconds, the specified settings are set.
After is displayed for 2 seconds, the monitor returns to the standby mode.
Dates up to December 31, 2050 are supported.
SYS
mmHg
DIA
mmHg
PUL
/min.
Year
Month
Day
Hour
Hour
Selected item
flashes
Minute