A&D UA-702 Instruction Manual - page 4

ENGLISH 3 

Symbols 

Function / Meaning 

Treatment 

Turns the device on and off. 

___________ 

Guide to install battery 

___________ 

Direct current 

___________ 

SN 

Serial number 

___________ 

Date of manufacture 

___________ 

Type BF: Device, cuff and tubing 

are designed to provide special 

protection against electrical 

shocks. 

___________ 

Appears when measurement is in 

progress and flashes when the 

pulse is detected. 

Measurement is in progress -

- remain still. 

Flashes when there is air 

remaining in the cuff at power up.  

Flashes at the completion of the 

measurement until exhaust is 

complete. 

Press the exhaust valve 

button to exhaust the air. 

The pulse is detected immediately 

after the measurement has begun. 

Increase pressurization by 30 

to 40 mmHg and measure 

again. 

Appears when the battery voltage 

is too low for the device to work 

properly. 

Replace all batteries with 

new ones. 

Appears when the blood pressure 

can not be measured accurately. 

First exhaust the air from the 

cuff, then re-apply the cuff 

properly and measure again. 

Appears when the pulse is not 

detected correctly. 

First exhaust the air from the 

cuff, then re-apply the cuff 

properly and measure again. 

Flashing 

exhaust 

velosity 

The exhaust rate is greater than 8 

mmHg/s. 

Adjust the exhaust rate to 2 

to 5 mmHg/s. 

The medical device label by the 

EC directive 

___________ 

Registered with the Australian 

Communication Authority by  the 

Trademarks office. 

___________