A&D UA-767 Plus Instruction Manual - Using The Monitor

English  7

Using the Monitor 

Attaching The Arm Cuff 

1. Wrap the cuff around the upper arm, 

about 2 - 3 cm above the elbow, as 

shown. Place the cuff directly against 

the skin, as clothing may cause a faint 

pulse and result in a measurement 

error. 

2. Constriction of the upper arm, caused 

by rolling up a shirtsleeve, may prevent 

accurate readings. 

3. Confirm that the index 

points within 

the proper fit range. 

How To Take Proper Measurements 

  For the most accurate blood pressure 

measurement: 

Sit comfortably at a table.   

Rest your arm on the table. 

Relax for about five to ten minutes 

before measurement. 

Place the center of the cuff at the same height as your heart. 

Remain still and keep quiet during measurement. 

Do not measure right after physical exercise or a bath. Rest for twenty or 

thirty minutes before taking the measurement. 

  Try to measure your blood pressure at the same time every day. 

Measurement 

During measurement, it is normal for the cuff to feel very tight. (Do not be 

alarmed) 

After Measurement 

After measurement, press the 

 START 

 button to turn off the power. 

Remove the cuff and record your data. 

Note:  The device has an automatic power shut-off function, which turns the 

power off approximately one minute after measurement. 

Allow at least ten minutes between measurements on the same person. 

Rolled up shirtsleeve 

2 -3 cm 

Constriction of the Upper Arm

Air Hose

Cuff 

Index

and Proper fit range