A&D UB-351 Instruction Manual - Measurements
English 10
Measurements
Before measurement, read “Notes for Accurate Measurement” on page 11.
Normal Measurement
1. Sit comfortably with the cuff at the same level as your heart
and relax.
2. Press the
START
button.
All of the display segments are displayed.
Then the display changes, as indicated in the figure at the
right, as measurement begins.
The cuff starts to inflate. It is normal for the cuff to feel very tight.
Note: If you wish to stop inflation at any time, press the
START
button again.
3. When inflation is complete, deflation starts automatically and
the
(heart mark) appears to indicate that the measurement
is in progress. Once the pulse is detected, the mark blinks
with each pulse beat.
4. When the measurement is complete, the systolic and diastolic
pressure readings and pulse rate are displayed.
The cuff exhausts the remaining air and completely deflates
automatically.
Note: If
the
MEMORY
button is pressed while the measurement
result is displayed, the reading is not memorized.
5. Press the
START
button again to turn the device off.
Remove the cuff.
Notes: The device is provided with an automatic power shut-off function.
Allow at least three minutes between measurements on
the same person.
START
button
Systolic
pressure
Diastolic
pressure
WHO
classification
Pulse rate
I.H.B. symbol
Inflation
in progress
Exhausts remaining
air automatically
Zero display
Starts inflation
All of the
display
segments
displayed
Measurement
in progress