A-Link PA500x2 Quick Installation Manual - page 11
11
2. Network settings for Internet connection
(Modify/check these settings when you want to use Internet)
Windows 7
1. Go to Start -> Control Panel.
2. Press View network status and tasks and then press a link Change adapter settings.
3. Move mouse over Local Area Connection icon and press right hand
mouse button on it. Choose Properties.
4. Choose Internet protocol version 4 (TCP/IPv4) -> Press Properties.
5. Choose Obtain an IP address automatically and Obtain DNS server
address automatically.
6. In properties of Internet Protocol (TCP/IP), press OK.
7. Press OK in Network settings.
8. Make sure that, no Proxy settings is enabled in Internet Explorer settings
9. Now your workstation is ready for Internet
Windows 8
1.
Press Desktop – icon on Windows 8 start screen.
2.
Press your mouse right hand button on network icon located at task bar.
3.
Choose ”Open Network and Sharing Center”.
4. Press a link Change adapter settings.
5.
Move mouse over Local Area Connection icon and press right hand mouse button on
it. Choose Properties.
6.
Choose Internet protocol version 4 (TCP/IPv4) -> Press Properties.
7.
Choose Obtain an IP address automatically and Obtain DNS server
address automatically.
8.
In properties of Internet Protocol (TCP/IP), press OK.
9.
Press OK in Network settings.
10.
Now your workstation is ready for Internet
Mac OS
1. Open AppleTalk -controller, choose Ethernet connection
2. Open TCP/IP -controller and modify these settings:
Connection = Ethernet
Definition = DHCP-server
3. Save settings. Now your workstation is ready for Internet
Copyright © 2014 A-link Ltd