A.O. Smith BTX-80 SERIES 100 Instruction Manual - page 29
29
for Your safetY read Before operatInG
warnInG:
If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury or loss of
life.
A. This appliance does not have a pilot. It is equipped with
an ignition device which automatically lights the burner.
do not try to light the burner by hand.
B.
Before operatInG smell all around the appliance area
forgas.Besuretosmellnexttothefloorbecausesome
gasisheavierthanairandwillsettleonthefloor.
what to do If You sMell Gas:
• Donottrytolightanyappliance.
• Donottouchanyelectricswitch;
Do not use any phone in your building.
• Immediatelycallyourgassupplierfromaneighbor’s
phone.Followthegassupplier’sinstructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in the gas control buttons.
Neverusetools.Ifthecontrolbuttonswillnotpushin,don’t
trytorepairthem,callaqualifiedservicetechnician.Force
orattemptedrepairmayresultinafireorexplosion.
D. Do not use this appliance if any part has been under
water.Immediatelycontactaqualifiedinstallerorservice
agencytoreplaceafloodedwaterheater.Donotattempt
to repair the unit! It must be replaced!
operatInG InstructIons
1. SetthethermostattothelowestsettingbyfirstpressingtheCOOLER and HOTTER buttons together and
holding for 1 second. Then press the COOLER button until the WARM indicator light appears.
2. SettheON/OFFswitchontheblowercontrolboxtothe“OFF”position.
3. Turn off all electric power to the appliance if service is to be performed.
Before operatInG: entIre sYsteM Must Be fIlled wIth water and aIr purGed froM all lInes.
1.
STOP! Read the safety information above,
on this label.
2. Setthethermostattothelowestsettingbyfirstpressing
the COOLER
and HOTTER
buttons together
and holding for 1 second. Then press the COOLER
button until the WARM indicator light appears.
3. Setthe“ON/OFF”switchontheblowercontrolboxto
the“OFF”position.
4. This appliance is equipped with a device which
automatically lights the burner.
do not trY to lIGht the Burner BY hand.
5.Waitfive(5)minutestoclearoutanygas.
Ifyouthensmellgas,STOP!Follow“B”in
thesafetyinformationaboveonthislabel.Ifyoudon’t
smell gas, go to the next step.
6. Turn on all electrical power to the appliance.
7. Setthermostattodesiredsettingbyfirstpressingthe
COOLER and HOTTER buttons together and
holding for 1 second. Then press the HOTTER
button.
8. If the appliance will not operate, follow the instructions
“TOTURNOFFGASTOAPPLIANCE”andcallyour
technician or gas supplier.
9. WATER TEMPERATURE ADJUSTMENT
isapproximately120°F.
cautIon: hotter water increases the risk
of scald injury. consult the instruction
manual before changing temperature.
warnInG: turn off all electrIc
power Before servIcInG
to turn off Gas to applIance