Part no.: revised on: revision: all the logo with ® has been changed. In front page service logo add. In page 16 guaranteed service add. In page 18 kolkata address & service detail add. Size: 210mm (h) x 148mm (w) part no.: 323238-000_r0 approved on: 30-05-2012 fit it & forget it why people prefer a...
Congratulations! And welcome to the a. O. Smith family. We would like to thank you for the trust you have shown in choosing an a. O. Smith water heater. You can be sure it will live up to your expectations. Thousands of delighted users all over the world trust a. O. Smith water heaters for their fam...
Contents specifications ......................................................................................... 1 key features ........................................................................................... 2 installation....................................................................
Specifications model hse-sbs-015 hse-sbs-025 volume [l] 15 25 power [w] 2000 2000 voltage/frequency [v/hz] ~230/50 ~230/50 actual stdg. Loss [kwh/24h/45°c diff.] 0.560 0.690 o max. Stdg. Loss [kwh/24h/45 c diff.] [as per is 2082:1993 amended in 2002] 1.138 1.386 reheating time for 35°c rise [in min]...
2 key features ® blue diamond glass lining anode rod safety valve glass coated heating element displays the temperature and the total energy consumed by the water heater. Temperature can be precisely set between 25°c to 75°c. It is easy to operate the water heater with wired remote controller even i...
Installation mounting fig. 1 position for installation fig. 2 wall mounting bracket 3 1. Make sure that the wall can withstand at least twice the weight of the water heater when completely filled with water. 2. Before locating the position for installation of the water heater, make sure that there i...
1. Open a hot water faucet nearby to permit the air to escape. 2. Open the cold water inlet valve fully, filling the heater and the piping. 3. Close the hot water faucet when water flows. 4. Check all the connections to see if there is any leakage. In case of a leakage, drain the heater completely, ...
For draining water from the water heater, following steps needs to be followed: 1. Switch off the electric supply to the water heater. 2. Open the hot water taps until the water is not hot any more. 3. Close cold water supply. 4. Drain the water by moving the lever of safety valve in the direction o...
Directions for use caution: before using the water heater, make sure the inner tank is completely filled with water and the power plug has been connected properly. It is recommended that the wired remote control box should be installed on the remote bracket (fig. 8). Ensure that the wired remote con...
7 temperature. While setting, the temperature indicators glow as shown in fig. 12. Note: • default set temperature (factory setting) is 70°c. 4. Energy meter the “energy meter” key is used to display the energy consumed by water heater for 5 seconds in kwh. The new value will be added to the consume...
8 ® a. O. Smith colourmatch system ® a. O. Smith colourmatch system allows you to match your water heater to the colour of your bathroom. Please visit www.Aosmithindia.Com and choose your decorative front panel colour options. Call a. O. Smith customer care centre [1.800.103.2468] to order the decor...
Troubleshooting note: call customer care centre on 1.800.103.2468 9 problem possible cause(s) solution • no display on heater is not plugged in plug in the heater wired remote thermal cutout trips call customer care centre • no hot water no power supply in power check the power socket socket on the ...
Circuit diagram black black blue thermal cutout power board element green/yellow red red red wired remote 10
Warranty product warranty warranty on tank 7 extended warranty* 4 11 your a. O. Smith water heater is warranted against defects arising from faulty design, workmanship and materials for a period of 24 months from the date of the invoice, subject to the following conditions: 1. The customer will noti...
General terms of warranty 1. The “goods” shall mean the goods described in the purchase agreement. 2. “the customer” shall mean the original purchaser under the purchase agreement. 3. “the company” shall mean a. O. Smith india water heating pvt. Ltd. 4. The “purchase agreement” shall mean the genera...
Warranty card (company copy) (to be sent back to the company) unit serial number: dealer’s stamp and signature invoice number: dated: customer's name and address: model: capacity: warranty card warranty card (customer copy) (to be retained by the customer) unit serial number: dealer’s stamp and sign...
Service and maintenance for service needs: please contact our a. O. Smith toll free number : 1.800.103.2468 sms us : +91770.292.8887 email us : aosmithcs@hotwater.Com for grievances please contact : wecare@hotwater.Com registered office a. O. Smith india water heating private limited plot no. 300, p...
Manufactured by a. O. Smith india water heating private limited plot no. 300, phase - 2, kiadb industrial area, harohalli, kanakapura taluk, ramanagara district - 562 112, karnataka, india. Toll free: 1.800.103.2468 website: www.Aosmithindia.Com p art no.: 323238-000_r1 dt:.
