A+V Link Technologies AVM-6995H-SYS-A1 Quick Setup Manual - page 7
A+V Link Technologies
PowerHDLink Quick Setup Guide
©2011 Copyright by A+V Link Technologies, Corp.
Version 1.0
7
Remote Controller Button Descriptions
Fig Area
Name
Description
Top Row
Active/Power Saving
Toggles the states of the TX and RX between Active mode and Power
Saving mode. Power Saving mode is the state you can set the TX and
RX to when not in use. In Power Saving mode, the RX & TX stop
sending video to the TV monitors and then revert to a low-power state.
The Power Saving mode for the RX and TX are independent of each
other and must be set at their respective locations.
Top Row
Link
Reserved
Top Row
Group
Use this button if the RX and TX cannot establish a connection (cannot
be paired). You also need to use this button when adding an additional
RX to your existing RX/TX environment (or group.). This button is also
used to allow the RX/TX to reset the system to factory defaults.
Top Row
Factory (only for RX)
Reserved
Source Select
next
source
Selects next input source of the TX. Similar to the “Source” button on
the TX. It is used to switch from the current input source to next (e.g.
HDMI-1, HDMI-2, HDMI-3, AV1, AV2 etc).
Source
Select HDMI-3
Change current TX input source to HDMI-3
Source
Select HDMI-2
Change current TX input source to HDMI-2
Source
Select HDMI-1
Change current TX input source to HDMI-1
Source
Select previous source
Move backwards to the previous TX input source. It is the opposite of
“Select next source”.
Source
Select AV2
Change current TX input source to AV2 (YPbPr)
Source
Select AV1
Change current TX input source to AV1 (CVBS/S-Video)
Source
Not in use
Reserved
Volume
Increase Volume (for RX)
Increase audio volume on the receiver
Setting
Display (for RX)
Toggle TV system between 59.94 Hz (NTSC) and 50 Hz (PAL).