A.W. Communication Systems DRC-32 User Instruction Manual - page 16
-Page 16 –
© A.W. Communication Systems Limited 2004
use [
↓
] or [
↑
] until the desired contrast level is observed. Press [
MENU
] to store your
settings, then, press [
CLEAR
] to exit the menu system.
Set Microphone Source
This item is likely to have been set by your system supplier; however circumstances
may require you to alter the setting should you connect a headset for the first time, or
have a headset failure and wish to revert to using the internal microphone.
Press [
MENU
] to access the menu system, then press [
↓
] until the chevron points to
Set mic source. Press [
MENU
] to select this item, then use the [
↓
] or [
↑
] to select the
microphone source, {Internal, or headset}. When the display indicates your desired
choice, press [
MENU
] to store your selection, then press [
CLEAR
] to exit the menu
system.
Lamp & Key Test.
The lamp and key test feature is a sub program used to test the buttons and illuminate
all of the lamps {L.E.D. devices}. This is a program which will run until cancelled.
The red “Transmit” key is used to stop the program and exit from this facility.
To access this facility, press [
MENU
] then [
↓
] until the chevron points to Lamp +
Key test. Press [
MENU
] to select this item and the sub program will run. The program
will illuminate the five lamps which should alternate between red and green in colour.
The button test takes the form of the display indicating the “column” and “Row”
number of any key pressed. For example, pressing the 3 key causes the display to
show 3x because the 3 key is part of the keypad matrix. Pressing the “group” key
causes the display to indicate C1.1 because the group key is the first key in column
one. Pressing the Transmit key shuts down the program and causes the DRC-32 to
reset.
Set Ident Name Tags.
Ident name tags are text labels which are associated with selective calling identities,
for example individual identity 23123 may be assigned “John Smith” or “Dog Van”.
Press [
MENU
] to access the menu system then [
↓
] until the chevron points to “set
ident tags”. Press [
MENU
] to select this item. The display will now change and
expect you to input the identity number you wish to tag. Be aware that the numbers of
digits expected are indicated by the number of dashed lines appearing in the display,
and so if three lines are showing, enter three digits. Having entered your digits press
[
MENU
] to select the ident ity. Two possibilities now exist.
1, an ident ity has not been previously entered for the chosen ident ity number, in
which case the Tag: line will be empty.
2, an existing tag will be in place which you can choose to keep, press [
MENU
] to
keep the existing tag and exit, or [
CLEAR
] to erase and edit the existing tag.
To enter a tag into a blank space, use the alpha-numeric keypad in the same way you
use a cellular telephone keypad to send an SMS. E.g. each press scrolls the key