A10 Thunder series 930 Installation Manual - Power-On
page 13 |
Document No.: TH-930-001 - 1/26/2015
A10 Thunder Series 930 Installation Guide
Power-On
Rack-mount installation instructions are available in
“Rack Mount Kit Installation” on page 27
Sliding rail installation instructions are available in
“Sliding Rail Kit Installation” on page 31
.
Power-On
The device automatically boots when the power plug is connected to an electrical outlet. If the unit does not boot automat-
ically, it can be manually booted by quickly flipping the power switch.
NOTE:
Power OFF – To perform a graceful shutdown, use the
shutdown
command in the CLI. If
you made any changes to the device configuration, you will be prompted to save your
configuration information before the device powers down.
Force Power OFF – If the system stops working and requires a forced shutdown, press
and hold the power switch four seconds. Keep in mind that this forced shutdown will
cause a loss of configuration information that has not be manually saved.
Supported Models
AX1030, AX3030, AX930
TH1030S, TH3030S, TH930
AX1030, AX3030, AX930
TH1030S, TH3030S, TH930
2-Post Installation?
Yes
No
4-Post Installation?
Yes
Yes
4-Post Depth
31 inches
36 inches
Mounting Thread
No
No
Double 4-Post
Yes
Yes
Default Bundle
Yes
No
Item
Rack Mount Kit
Sliding Rail Kit