A10 Thunder series 930 Installation Manual - Center Mount Installation
of
44
page 29 |
Document No.: TH-930-001 - 1/26/2015
A10 Thunder Series 930 Installation Guide
Center Mount Installation
Center Mount Installation
This section provides instructions for a center mount installation.
1. Align a bracket over the 6 black 4-mm flat-head screws that will be used to attach the bracket to the chassis. Make sure
to use the correct bracket. Each bracket fits on only one of the chassis sides.
2. Remove the screws.
3. Align the bracket over the screwholes and re-insert the screws. Make sure they are snug.
4. Repeat these steps to attach the other bracket
5. Attach the Thunder device to the center post in the rack. Make sure to fasten the brackets.
6. Check all the screws to verify that they are snug.