A2B Electronics ECX-200 Installation Manual - page 13
13
The ASI output contains the services you have selected for [Digital
output].
For decryption you mark the service by a click on the service name line
and by clicking on “Enable” under the [Decryption] headline.
Note! To decrypt more than one service requires a multidecryption CA
module and a smartcard that is activated for more than one service. Some
smartcards can handle two or three services at a time. Please, refer to
your smartcard service provider for further information.
Click the “Network settings” and select “Network ID” and “Transport ID”. If
a choice is made you have to click on [Save] to store the ID:s. The DVB
standard recommends following Network ID ranges:
DVB-S: 0 to 8191 (0 should be avoided)
DVB-T: 8193 to 13568 (Boxer in Sweden use 8945)
DVB-C: 40961 to 65281 (ComHem in Sweden 41001 and up)
The ECX-200 is designed to perform remultiplexing fully automatically of
both audio and video streams as well as full remultiplexing and
regeneration of PSI/SI data.
The advantage for you as a user is much lower risk of failure and the
process is much less time consuming.
In the menu to the right a list of
all services the unit receives,
both from the [Tuner input]
and from the [ASI input].
To select the service or services
you want at the [Digital
output] mark a service by
clicking the line where the
service is presented and than
click the “Set digital” button.
Now an “X” should appear in the
“Dig” column. Do the same to
choose a service as “Analogue
out”. Make your choice of which
services you want to select as
outputs and you will see the
selected service(s) in the
[Digital output] list in the
menu.
4. Settings (continued)
English