A2B Electronics ECX-200 Installation Manual - page 21
21
This specification may change without prior notice.
MPEG Decoder - Audio
Supported formats MPEG 1 layer II, AAC HE,
Output
Selection of Dual mono in,
Stereo or Mono
Impedance
< 100 Ω
Output level
0 dBu
Supported formats MPEG2 MP@ML, MPEG4 h.264 AVC
Output standards
PAL, SECAM or NTSC
Impedance
75 Ω
Output level
1 Vpp @ 75 Ω
Aspect Ratio
Letterbox, Pan/Scan,
or conversion
Combined (14:9)
programmable, WSS
Teletext
Insertion in VBI
Subtitling
Teletext or DVB subtitling
Decryption
Common Interface
MPEG Decoder - Video
Graphical User Interface for easy set up of complex
systems. Simple handling of remultiplexing
and creation of new multiplexes from any input.
Default setting of PSI/SI tables to avoid clashes in the
output multiplexes.
Simple structure for setting input, output and processing
parameters.
Each ECX-200 contains an embedded web server.
Standard web browsers (Internet Explorer, Mozilla Firefox
etc.) are supported
Graphical User Interface (GUI)
ASI bit rate
270 Mbit/s
Max payload bitrates:
Max input bit rate
55 Mbit/s *)
Max output bit rate
55 Mbit/s *)
PCR restamping
Yes
PSI/SI management
Yes
Remultiplexing
Yes
*) The input, output and throughput bitrate is highly
dependent on the type of application that is run in the unit.
ASI input(option) – output
Each ECX-200 contains a remultiplexer for 2 incoming
transport streams. The transports streams can be received
from a cable network and from the ASI input. All PSI/SI
regeneration in a Head end system is handled over IP.
Following components can be remultiplexed:
Audio, Video, Subtitling, PAT, PMT, NIT, EIT, TDT, CAT, SDT
Remultiplexing (option)
English