Aaeon EMB-H110B Manual - 3.3.7
3-7
Chapter 3: BIOS setup
Tolerance of Temperature [0]
Input value range: [0~7]
Fan Out Start-Up Value [127]
Input value range: [0~255]
Fan Out Stop Value [100]
The Fan Out value decreases to this value if the temperature reaches below
the lowest temperature limit. Input value range: [0~255]
Fan Out Stop Time [60]
Determines the amount of time it takes for the Fan Out value to fall from the
stop value to zero. Input value range: [0~255]
Critical Temperature [75]
Determines the amount of time Fan Out takes to decrease its value by one
step. Input value range: [0~255]
Fan Out Step Up Time [10]
Determines the amount of time Fan Out takes to increase its value by one
step. Input value range: [0~255]
Fan Out Step Down Time [10]
Determines the amount of time Fan Out takes to decrease its value by one
step in intervals of 0.1 seconds. Input value range: [0~255]
The following items appear only when you set Fan Control Mode to [Speed
Cruise Mode].
Target Speed [0]
Input value range: [0~4096]
Speed Tolerance [2]
Input value range: [0~64]
Fan Out Step Up Time [10]
Input value range: [0~255]
Fan Out Step Down Time [10]
Input value range: [0~255]
Critical Temp Tolerance [xx]
Input tolerance of critical temperature. The values range from 0~7.
The following item appears only when you set Fan Control Mode to [Manual
Mode].
PWM/DC Voltage Output [255]
Sets the voltage allocated for Fan Control. Input value range:
[0~255]
The following item appears only when you set Fan Control Mode to [Thermal
Cruise Mode].
Temperature source [SYSTIN]
Allows you to select the temperature source. Configuration
options: [SYSTIN] [CPUTIN] [AUXTIN0] [AUXTIN1] ~ [BYTE_
TEMP]
3.3.7
Power Management
Power Mode [ATX Type]
Select power supply mode. Configuration options: [ATX Type] [AT Type]
The following items appear when you set Power Mode to [ATX Type].
Power Saving (ERP) Control [Disabled]
This item configures power mode for power saving function.
Configuration options: [Disabled] [Enabled]
Restore AC Power Loss [Last State]
[Last State]
The system goes into either off or on state, whatever the system
state was.
[Always On]
The system goes into on state after an AC power loss.
[Always Off]
The system goes into off state after an AC power loss.
RTC Wake system from S5 [Disabled]
[Disabled]
Disables system wake up from S5.
[Fixed Time]
The system will wake up at the specified hr::min::sec.
Configuration options: [Disabled] [Enabled] .
[Dynamic Time]
The system will wake up at the current time plus a specified
number of minutes.
The following items appear when Fixed Time is enabled.