AAS 16-X1 ASCENT X1 Installation And Operating Manual - page 15
Page 15 American Access Systems / Security Brands, Inc.
Event Input -- Sub-Mode 9
DETAILS: Programming Sub-Mode 9 allows a user with Master Code privileges to program the unit to connect to an
external device to control a specific function.
Note: Relay A codes can be turned off by an external switch. When inactive, all Relay “A” codes
will be disabled. However, the Relay “B,” program and function codes will continue to be accessible
to the Master user.
NOTE: If you do not wish to toggle the MODE that the unit reports, enter pound (#) key to exit. Event
Input can be programmed 4 separate ways:
1. To program Event Input as Remote Inactive:
• Enter the MASTER CODE
• Unit will sound a GOOD TONE
• Enter the numeral 9 (Unit will sound the Current Mode*)
• Unit will sound a GOOD TONE
• Enter the numeral 1
• Unit will sound a GOOD TONE
2. To program the Event Input as an Arming Circuit:
• Enter the MASTER CODE
• Unit will sound a GOOD TONE
• Enter the numeral 9 (Unit will sound the Current Mode*) followed by a GOOD TONE
• Enter the numeral 2
• Unit will sound a GOOD TONE
3. To program the Event Input as Remote Open:
• Enter MASTER CODE
• Unit will sound a GOOD TONE
• Enter the numeral 9 (Unit will sound Current Mode*) followed by a GOOD TONE
• Enter the numeral 3
• Unit will sound two quick tones in succession then wait for input
• Enter the Relay to Activate
Enter the numeral 1 to activate relay A
OR
Enter the numeral 2 to activate relay B
• Unit will sound a GOOD TONE4. To DISABLE the Event Input:
• Enter the MASTER CODE • Enter the numeral 9 (Unit will sound Current Mode*)
• Enter the numeral 0 to Disable
• Unit will sound a GOOD TONE
*Current Modes
Single Tone Indicates:
Remote Inactive Mode is Enabled
Double Tone Indicates:
Arming Circuit Mode is Enabled
Triple Tone Indicates:
Remote Open Mode is Enabled
GOOD TONE Only:
Event Input Disabled
NOTE: If you do not wish to toggle the MODE that the unit reports, enter # to exit.