AASSET Security AST CD 103 VP EX User Manual - page 3
Using the camera externally
9. Power connector (2 pin)
Apply silicon compound to pretect against humidity
Connect the power cable (supplied) to the 2 pin connector
which will cause condensation on the lens and inside the cover
. On the holes (4) when the camera is waal or ceiling mounted
10. Cable access
. On any holes not used
Loosen the screw and remove the connector to use cable access
. On the base of the housing
11. Security attachment
Monuting template
The security cord attaches the cover to the housing
A mounting template is included for marking fixing holes
12. Dome cover
The dome cover is made of shock resistant polycarbonate
The figure shows the dome with the base removed
Pass the cable through the conduits fitted to the face and the lower part of the base
The connectors are pre-fitted. Use connectors as necessary
2.Zoom Ring
Turn the zoom ring until you obtain the desired image
The zoom ring is locked by fastening screws. Tighten the fastening screws until the ring is fixed in position
3. Focus Ring
Turn the focus ring until the image is clear and sharp
The focus ring is locked by fastening screws. Tighten the fastening screws until the ring is fixed in position
4. Dip switch adjustment (colour model)
The Dip Switches are factory set (in grey)
1: ESC
Use this switch to activate automatic shutter mode
2: FLK (anti fliker)
Use this switch to avoid flicker caused by some fluorescent lighting
(a) BNC for monitor or video device
3: BLC (Back light compensation) ON/OFF switch
(b) Power supply cord (12VDC/24VAC)
Use this switch to give definition to backlit subjects (default: OFF)
(4) Holes for fixing the housing
(5) Holes for cable access (in the base)
4. Clean the hole on the base before joining and install the connector firmly to prevent moisture
4: AWB/AWT : White balance switch. AWT for automatic.
entering the housing
5. Dome housing
Dome housing is made of cast aluminium
.
To prevent short circuits, avoid touching together the power cables when making the connection
6. LEVEL - Level adjustment (lens)
Used to compensate for varying light levels, turn towards (low) for darker image
Turn towards (high) for clearer image
Camera can be wall or ceiling mounted
Page 2
page 3
1.Hole (3/4")
The video and power cables are passed through the conduit in the dome base (at the factory)
1. Using the holes on the side of housing, remove all cables
3. Attach the BNC connector to to connector CN204 (1). Attach the power cord to
the power supply
7. Installation of the camera
2. Plug the hole using the screw
Install the camera using the fixing screws (3) provided with the camera
Connect the cables to connectors (a) and (b) respectively
.
The connector is a quick connect system. The cables are screwed on the connector block tip
Attach the BNC connector to the monitor
8. Video connector (2 pin)
The screws block and the washers cover the holes
Installation of the Camera
Warning
Using the cable access holes
Using the cable conduit
Functions and identification of camera parts
A
Connection
B