AASSET Security AST CD 103 VP EX User Manual - page 4
When installing the conduit, ensure the tube is inserted poperly, otherwise moisture and dust
. If the camera will not move, loosen the screw again to move it. Be sure to tighten the
can penetrate
screw again after adjustment
When installing the card, ensure that the conduit is clean and dry, insert the card firmly,
and use a good quality silicone compound
Ensure that the screw pitch is 12mm or less, or the thread may be damaged
The camera is mounted in the same way as a ceiling mount
(1) Lock
(4) Pan angle
(2) Zoom setting
(a) Loosen/Unlock
(3) Focus setting
(b) Fixing
(1)Base (2)Cover
(3)Screw
(4)Screwdriver (provided)
1 Hold the lens so it doesn't turn. Loosen the screw by turning it in the
direction of the arrow (Anti clockwise)
. Take care not to leave finger marks on the cover. Wipe any marks with
a soft cloth
Hold the lens and lock the ring, otherwise the lens can move due to vibrations or
. Before mounting, clean the joints on the top and the base
twisted lens cable
1 Line up the screws with the holes on the base
2. Turn the lens in the desired direction
2 Hold the cover in place and tighten the 3 screws with the tool provided
du tournevis fournie.
Do not turn the lens more than 360 degrees, or the cables may break
The following may be observed under certain conditions. They are due to
characteristics of the CCD. Please do not try to adjust the camera:
3 When the lens is in the desired position, tighten the screw and lock the ring
at a strong light source
Noise on Screen:
Noise can appear on screen when the CCD is running
at a high temperature
4 Loosen the zoom ring slightly, and turn it till you find the desired angle
Jagged egdes:
This can be observed if there are sharp and straight edges
5 Loosen the focus ring slightly, and turn it till you see a sharp picture
in the image
6 Repeat stages 1 to 5 till image is clear
7 After adjusting the focus and zoom, lock down the rings by tightening the screws
Capture device
Interline Transfer 1/3" CCD
After adjusting the zoom and focus, the screws must be tightened or the settings may change,
Pixels
AST CD 103VP EX / AST MD 301-2 / AST CD 101 VP-2 : 752(H)*582(V)
for example, due to temperature change
Signal system
AST CD 103VP EX: Colour / B&W Exview
AST MD 301-2: B&W
8 Hold the lens still, and tighten the ring screws (clockwise)
AST CD 101 VP-2 : Colour
Page 4
Vertical Smear:
This can happen when the camera is pointed directly
Page 5
Warning
Pan tilt Ajustement / Focus Adjustemtent
Mounting the dome in a ceiling
Warning
Notes
Warning
Notes
Mounting the dome on a wall
Warning
CCD characteristics
Specifications
Closing of the dome base and cover
E