AAT KZ-1000-IP-M Installation Manual - page 12
Integrated Access Controller – Installation manual
All rights reserved. © AAT HOLDING S.A.
12
6.1 Adding a package of cards
After entering the programming mode enter the code 31, then
Enter the ID of the first user of the package
Close the cards one of the other to the reader
After read each card reader will generate a single beep.
Repeat the operation for the next card
After loading press #
Read the card will be credited automatically generated ID numbers. The process
is best preceded by the preparation of a list of IDs, user names and card num-
bers.
6.2 Adding a single card
After entering the programming mode enter the code 32, then
Enter the user ID from the list
Close the cards one of the other to the reader
After you read the card reader will generate a single beep and automatically exits
the programming mode.
6.3 Adding a package of cards with PIN codes (6 digits)
After entering the programming mode enter the code 33, then
Enter the ID of the first user of the package
Close the cards one of the other to the reader
Enter the PIN -> enter the PIN again
Repeat the operation for subsequent reading cards with PIN codes
After each added card reader generate a single beep. Read the card will be cred-
ited automatically generated ID numbers.
After loading press #
6.4 Adding a single card with a PIN code
After entering the programming mode enter the code 34, then
Enter the user ID from the list
Close the cards one of the other to the reader
Enter the PIN -> enter the PIN again
After you read the card and enter your PIN, the controller will generate a single
beep and automatically exits the programming mode.
6.5 Adding a group of users with PIN codes
After entering the programming mode enter the code 35, then
Enter the ID of the first user of the package
Enter the PIN -> enter the PIN again
Repeat the operation to enter PIN codes for next users
After each added user controller will generate a single beep. PIN codes entered
will be added to the next automatically generated ID numbers.
after loading press #
6.6 Adding a single user with a PIN code
After entering the programming mode enter the code 36, then
Enter the user ID from the list
Enter the PIN -> enter the PIN again
After a user added the controller generates a single beep and automatically exits
the programming mode.