AAT KZ-1000-IP-M Installation Manual - page 14
Integrated Access Controller – Installation manual
All rights reserved. © AAT HOLDING S.A.
14
Programming codes table - standalone mode
Parameter name
or function
Function code
(after enter into programming mode)
Programming mode
Enter programming mode
* plus admin code PIN
Exit the programming mode
#
Basic parameters
Controller initialization
11
Enabling alarm
Disabling alarm
121
122
Tamper alarm
13 (00 disable 01 enable)
Exit button input line parameters
141 (01 - type NO, 00 - type NC)
142 (00 disable 01 enable)
Door magnet input line parameters
Door open delay (unlock time)
Door open time-out (after unlock time-out)
151 (01 - type NO, 00 - type NC)
21 (00 - 99) sec., 3 sec. default
152 (00 - 99) sec., 3 sec. default
Alarm input line parameters
Alarm action delay
Alarm relay output
161 (01 - type NO, 00 - type NC)
162 (00 - 99) sec., 0 sec. default
163
(1-RL1, 2-RL2, 3-RL1&2, 4–no out)
Access mode setup
Card only
221
Card + PIN
222
PIN only
223
Card or PIN
224
User management
Add card continuously
31
Add single card
32
Add card + PIN continuously
33
Add single card + PIN
34
Add user with PIN continuously
35
Add single user with PIN
36
Delete single card
37
Delete all cards
38
Admin password setup (programming mode)
41
Threaten code setup
42
Notes: Default admin code 000000 must be change after first enter into programming
mode for own using 41 command code. Leave default code allows unauthorized persons
enter into programming mode and add own card. Reset admin password is available
from KaDe Premium Plus software - > Controller setup -> Management password. New
password should be download to the controller.