AAxeon FCM-3312SX User Manual - page 2
PN: 6306X3312000XXX
4. LED Description
LED
Color
Function
Power
Green
Lit when power is available
TX/Link
ACT
Green
Lit when TP cable connection with
remote device is good
FX/Link
ACT
Green
Lit when Fiber cable connection
with remote device is good
FDX/COL
Green
Lit when TP works in Full Duplex
mode
Status
Green
Orange
Lit when Local or Remote Fiber
Link is O.K.
Blinking when testing success
Lit under below condition:
Remote/ Local FX/TX port link down
Connect device 3312 series
Blinking when testing failure
10/100
/1000M
Green
Orange
Lit when TP link in 100M
Lit when TP link in 1000M
Notice: Due to IC special specification the
FX/Link/Act LED keep flashing while port link down in
most cases.
5. Technical Specifications
Standards
IEEE 802.3z, 802.3ab ,802.3u
Interface
1 X RJ45 connector
1 X SC connector
Diagnostic LED
Power, FDX, Speed (1000/100/10)
TP Link, FO Link, Status
Power Consumption
3.7W
Dimensions
119mm(W) X 86mm(D) X 25(H) mm
Shipping Weight
1LB
Temperature
Operating: 0 ~ 40
o
C
Storage: -20 ~ 60
o
C
Humidity
5% ~ 90% RH
Emission
EMI: FCC / CE Class A
Media
TP EIA/TIA-568 Cat 5e, 100M
Multimode Fiber
50/125, 62.5/125um multimode fiber
Single-mode Fiber
9/125, 10/125um single-mode fiber
6. Configuration
The OPTOLINX GIGABIT MEDIA CONVERTER supports
configuration via the FCM-CHS2 Converter Chassis. It can
configure Speed, Duplex, Auto. Please refer to the
FCM-CHS2 Converter Chassis for the detail information.
7. DIP Switch
Pin
Function
Description
Pin 1
TP Auto-Negotiation
On
Enable
Off
Disable
Pin 2
Pin 3
TP Speed
Pin2:Off Pin3:Off
10M
Pin2:On Pin3:Off
100M
Pin2:Off Pin3:On
1000M
Pin2:On Pin3:On
1000M
Pin 4
TP Duplex
On
Full
Off
Half
Pin 5
Flow Control
On
Enable
Off
Disable
Pin 6
FIB Auto-Negotiation
On
Enable
Off
Disable
Default is set to ON from PIN 1 to PIN 6
Please perform Power On reset after modifying the
Dip Switch setting and firmware update
8. Diagnostic
The OPTOLINX GIGABIT MEDIA CONVERTER built-in
remote diagnostic function, when you link with the
FCS-3312 under fiber cable. You can use the front panel
diagnostic push button or FCM-CHS2 Converter Chassis
management function to test remote module status.
FCM-3312SX
Gigabit Smart Diagnostic
Media Converter
User’s Guide
v1.6