ABB aquamaster Quick Reference Manual - page 4
4
>217
<0>217=42
>217=42
<3>217=Write Access Denied
Comments
>248=setup
<0>248=2 logged in enter password
>112
<0>112=1 l/s
read present flow units
>115
<0>115=250
read present fsd
>115=10
<0>115=10
set new fsd value of 10
>112=6
<0>112=6 m
3
/m
set units to number 6 (m
3
/min)
Flow Units
: l/s
Flow Units?
l/s
Flow Units?
l/m
Flow Units
: l/m
FSD(100% or URV) 200 l/m
(Repeat space function key until
required units are displayed)
Tab
Space
Space
PARAMETER CHANGES
Note. Use
Esc
to escape or cancel in input
mode, or to exit a menu.
Where
217 is the number for the flow rate
<0> is the error code for 'no error'
42
is the current flow rate
<3> is the error code for 'Write Access Denied',
since writing to the flow rate is not allowed.
To change the flow FSD to 10 m
3
/min:
To cancel the password security, press
Esc
until the front screen is reached.
Changing Selections
Note. Ensure that the correct access level is selected.
It is possible to enter data directly into the AquaMaster without navigating the menu system. This is
achieved by using the 'Command Line Interface' (CLI). To read the value of a variable, type
>
followed by the variable number (see overleaf), then press
.
To write a new value to a variable, type
>
, the variable number,
=
and the new value required, followed
by
. In both cases the AquaMaster will reply with the new value of the variable (or a reason for failure) e.g.: