ABB EXCOUNT-II User Manual - page 12
12
2501en EXCOUNT-II Users Manual
Transceiver menu system
1.3.3 Resistive leakage current
measurement *
)
Select sensor ID to read data from with the key.
Start the reading by pressing
Before the transmission begins the operating voltage
must be given.
(see 1.3.3.1)
A successful transmission is marked with
A failed transmission is marked with
If the transmission was unsuccessful, an error code
will be displayed.
Back to read data menu
*) Not available in all versions.
Progress bar
Error code
1.3.3.1 Operating voltage *
)
The actual operating voltage must be given when
measuring the resistive leakage current.
The system voltage is displayed as a default value.
Adjust the value to the actual value with
and keys.
Enter the correct value by pressing
NOTE! If the system is 3-phase, the value should
be the actual phase-phase voltage. Otherwise, for
1-phase systems, the value should be the phase-
ground voltage.
The progress bar will indicate that the transmission
has begun.
*) Not available in all versions.