Abbott CELL-DYN 3000 Operator's Manual - Operating Instructions

CELL-DYN

 3000 System Operator’s Manual 

5-1

9140240E — May 1995

Chapter 5

Operating Instructions

Introduction

This chapter discusses the operation of the CELL-DYN® 3000. It is 

divided into three sections: 

Set Up Instructions

,

 Routine Operation

 and 

Using the Data Log

. The chapter also includes an overview of the Data 

Station computer program. The three major menus in the program that 

are used for routine operation — 

Set Up

, 

Run 

and the 

Data Log

 — are 

discussed in this chapter. The remaining parts of the program are 

discussed in the following chapters:

Calibration 

— Chapter 6

Quality Control  — Chapter 7

Maintenance  — Chapter 9

Troubleshooting  — Chapter 10

Data Station Program Overview

The Data Station menus are presented as key labels displayed across the 

bottom of the screen. Each menu is accessed by pressing the soft key 

located directly below the label. (From left to right, these soft keys 

correspond to keys F1–F8 on the standard computer keyboard.)

When the Data Station is powered ON, the 

MAIN MENU Screen

, 

depicted in 

Figure 5.1

, is displayed. The key labels displayed across the 

bottom of this screen are used to access all of the sub-menus that are 

available. The MAIN MENU keys are listed below.

MAIN MENU KEYS:

SETUP

RUN

DATA LOG

QC LOGS

CALIBRATION

DIAGNOSTICS

SPECIAL PROTOCOLS

Search

Go Back

Book TOC