AbCoaster Pro Owner's Manual - Assemblyinstructions
Step 1: Attach rear foot
(without wheels) to rear of
curved track. Remove the 2
bolts which have been pre-
attached to the rear foot,
then re-attach the bolts to
connect foot to track. Finger
tighten bolts only. Do not
tighten bolts with tool until
unit is fully assembled.
Step 2: Attach front foot
(with wheels) to front post
using the 2 pre-attached
bolts. Finger tighten only.
ASSEMBLYINSTRUCTIONS
IMPORTANT:Removeallpartsfrompackingandinspectfor
damage.Retainpackingmaterialsifpossible.
CAUTION:Donotcutandremovetheplasticstrapwiththislabel
attacheduntilunitiscompletelyassembed.Thestrapkeepsthe
SEATsecuretotheCURVEDTRACKforeasyassembly.
FRONT POST
CURVED
TRACK
ARMREST
CONSOLE
SEAT
REAR
FOOT
Your Ab Coaster® Pro has been thoroughly inspected and partly assembled
before shipment. You will need to take a few additional steps as described
below to complete assembly. If you have any questions, please call our
customer service center at 973-287-5180.
Step1:AttachRearFoot
Step2:AttachFrontFoot
Step3:AttachFrontPost
Step4:AttachArmrestConsole
Step5:ConnectWires
4
FRONT
FOOT