Abi JY-130B User Manual - page 6
3. Front Control Panel:
⑴.HOME:
When the camera is in operating, press this button for 3 seconds, it will stop transmitting image
and go to standby, if press for another 3 seconds, the camera will get back to work again.
⑵.AV:
Switch the input signal source ( video1 or video2).
⑶.PC:
Switch between PC1 & PC2.
⑷.AC:
Perform white balance automatically.
⑸.BRT+、BRT-:
Image brightness control.
⑹.SHARPNESS+、SHARPNESS-:
Image sharpness control.
⑺.P/N:
Switch the image mode between positive and negative.
⑻.LAMP:
Lamp control, switch the lighting mode as up lamp - down lamp- all turned off - up lamp, etc.
⑼.AF:
Auto focus button.
⑽.ZOOM+/ ZOOM-:
Image zoom in and zoom out control.
⑾.FOCUS+/FOCUS-:
Adjust focus manually.
⑿.FRZ:
Image control, switch between shoot and freeze.
⒀.FN:
Function button
,using with other buttons for special functions.
Control with FN button
⑴. FN+LAMP:
Switch the image between text mode and dynamic mode. Text mode gives sharper and
better-colored images when showing printed material.
⑵. FN+BRT+、FN+BRT-:
Image chroma control (red).
⑶. FN+SHARPNESS+、FN+SHARPNESS-:
Image chroma control (blue).
⑷. FN+ZOOM+、FN+ZOOM-:
MIC volume control.
⑸.FN+PC:
Capture the image in the screen. (Available for models with image capture function).
⑹.FN+AV:
Multi-image mode enabled
;
(Available for models with image capture function)
Press again to return to normal mode.
In multi-image mode:
ZOOM+:
Display the first image
.
FOCUS-:
Display the second image
.
ZOOM
-:
Display the third image
.
FOCUS
+:
Display the fourth image
.
FN+AF
:
Images page turning.
⑺.FN+FOCUS-:
Output right-and-left mirror image.
⑻.FN+FOCUS+:
Enable the function of side-by-side images comparison on same screen.
5.