Summary of eMH1 513
Page 1
Version: 513/824-2016-07-15 emh1 wallbox instruction manual emh1 513/824.
Page 2: Contact
Ii contact manufacturer abl sursum bayerische elektrozubehör gmbh & co. Kg albert-büttner-straße 11 91207 lauf / pegnitz germany phone +49(0)9123 188-0 fax +49(0)9123 188-188 web www.Abl.De email info@abl.De support phone +49(0)9123 188-600 email emobility.Support@abl.De.
Page 3
Iii a b c.
Page 4
Iv d e.
Page 5
V g h f.
Page 6
Vi.
Page 7: Contents
Vii contact ii introduction 1 meaning of the safety information 1 general safety information 1 warnings 1 product overview 3 description 3 evse 513 charging station scope of delivery (fig. A) 3 residual direct current (‘dc residual current’) 3 assembly 5 assembly location 5 opening the charging stat...
Page 8
Viii checking the rccb (fig. H) 8 lockable panel 8 troubleshooting 9 care and maintenance 10 specifications 11 conditions of operation 11 declaration of compliance 11 disposal note 11.
Page 9: Introduction
Introduction 1 introduction this operating manual contains important information about the installation and safe operation of the device. Please make sure to read and observe the safety instructions provided. All safety information in this operating manual must be passed on to all users. Meaning of ...
Page 10
Introduction 2 (a) (b) (a) read operating manual before opening (b) warning: dangerous electrical voltages consult the operating manual (a) (b) (c) (a) warning: (b) potential risk of electric shock from residual direct currents (c) for further information, see the operating manual danger! • the elec...
Page 11: Product Overview
Introduction product overview 3 product overview description the charging station allows safe and convenient charging of electric vehicles in ac- cordance with iec 61851-1, mode 3. In this mode, the charging station ensures that the vehicle is only supplied with electrical energy if the vehicle is c...
Page 12
Product overview 4 volkswagen vehicles), obtained from authorised dealers or even from the manu- facturer themselves. • if you do not know whether the vehicle has a residual current protective device, it may not be connected to this charging station. In this event, additional protective measures are...
Page 13: Assembly
Product overview assembly 5 assembly assembly location the charging station is designed for outdoor use (splash proof). In order to best protect the appearance of the charging station, it should only be installed in locations that are not exposed to constant, direct sunlight. We recommend installing...
Page 14: Mounting Height (Fig. D)
Assembly 6 mounting height (fig. D) a mounting height of 150 cm is recommended for a 3-m charging cable. Electrical connection (fig. E) warning! Before operating, installing or opening the charging station, read and ob- serve the safety information provided. Switch off the power before ope- ning the...
Page 15: Operation
Assembly operation 7 operation charging process and led indicators (fig. F) the charging process complies with iec 61851-1 mode 3 step led f2 (green) led f1 (blue) description ready off short flash every 5 s power supply connected to the vehicle inlet off on vehicle detected, charging starts automat...
Page 16: Checking The Rccb (Fig. H)
Operation 8 removing the coupler from the charging station (fig. G) disengage the coupler by first lifting the coupler in the direction indicated (g1) and then taking it out of its bracket (g2). Checking the rccb (fig. H) the rccb (h1) should be checked at least every six months! When pushed, the rc...
Page 17: Troubleshooting
Operation troubleshooting 9 troubleshooting in the event the rccb triggers, open the panel with the supplied key and use the lever reset the station to operating mode. If the rccb is triggered again, this may indicate a fault that can only be repaired by trained personnel. Please note that any inapp...
Page 18: Care and Maintenance
Care and maintenance 10 care and maintenance • the charging station can be cleaned with a dry cloth. • harsh cleaning agents may cause the displays (led indicators) to become dull. • never use a pressure washer or similar device to clean the charging station. • the built-in rccb situated below the p...
Page 19: Specifications
Care and maintenance specifications 11 specifications conditions of operation storage temperature −30 ˚c … 85 ˚c operating temperature −30 ˚c … 50 ˚c humidity 5 % … 95 % rh (non-condensating) rated voltage 230 v 50 hz rated current 16 a overvoltage category iii class of protection i protection degre...
Page 20: Made In
Albert-büttner-straße 11 d-91207 lauf / pegnitz tel. +49 (0) 9123 188-0 fax +49 (0) 9123 188-188 info@abl.De www.Abl.De abl sursum bayerische elektrozubehör gmbh & co. Kg made in germany.