ABL eMH1 Instruction Manual - page 13
inStallatiOn and pOwer Supply cOnnectiOn
9
Installation and power supply connection
The electrical installation of the eMH1 charging station model variants described in this
manual must always be carried out by qualified specialist personnel: Please contact an
electrical contractor or arrange installation at your premises with your local distributor.
However, as a user you may carry out the mechanical installation of the charging sta-
tion yourself, as long as you follow the safety notices and general instructions.
Prerequisites for the mounting site and installation
Your eMH1 charging station is an electrical device and is therefore subject to particular
prerequisites for indoor and outdoor installation: Although the housing of the eMH1
complies with the standards for the IP44 degree of protection, you must take into ac-
count certain environmental conditions, especially outdoors.
In selecting the mounting site you must consider the following points:
• For the safe operation of your charging station, minimum distances to other tech-
nical installations must be observed: You can obtain further information from your
electrical contractor or your distributor.
• The charging station must be installed where it is freely accessible to all authorized
users.
• Ideally, the mounting site should already provide a connection to the power supply.
If not, a separate supply must be installed that complies with the generally pre-
scribed standards for cabling and building infrastructure: Please contact a qualified
electrical contractor for details.
WARNING!
The power supply for the eMH1 must ALWAYS be protected by a domes-
tic miniature circuit breaker (MCB) .
Some model variants require the supply cable to be protected by an addi-
tional external FI residual current circuit breaker (RCCB). Further informa-
tion available under Technical Data, see page 11.
• This charging station is intended exclusively for connection to and operation on a
rated voltage of 230 V 50Hz ( EVSE 512 / 562 / 572) or 230 / 400 V 50 Hz (EVSE 502 /
522 / 552).
• The power supply cables may be installed above or below the wall surface. How-
ever, the cable should preferably enter the device through the inlet on the underside
of the bottom part of the housing.
• Sufficient air circulation must be ensured at the mounting site so that the charging
station is cooled during operation: Always observe the allowed operating tempera-
tures (see “Specifications” on page 22).