Powerlink 4 control unit user manual read this entire manual before operating this device. English español français deutsch.
2 symbols the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Warning: indicates the possibility of injury associated with use or misuse of the...
3 table of contents product map/features 4 using the powerlink 4 basic setup and use 5 linking with ablenet wireless devices 5 modes of control 6 direct latched timed 2-switch count troubleshooting 7 maintenance 7-8 care cleaning storage technical specifications 8 regulatory 8 warranty/repair/return...
4 powerlink product map & features mode button: use this button to cycle between powerlink’s 6 modes of control. Mode leds provide visual feedback. Status buttons: use these buttons for testing the powerlink’s connection to attached appliances. Status buttons are also used when linking ablenet wirel...
5 using the powerlink 4 basic setup and use plug the powerlink into any ac wall outlet with the cord provided and turn the device on. 1. Plug appliance(s) to either power cable on the side of the powerlink and turn the 2. Appliance(s) on. Note: for pressure sensitive switches, consider tape or a vel...
6 modes of control the powerlink control unit offers six modes of appliance control: direct, count, two-switch, timed seconds, timed minutes, and latch. Press the “mode” button repeatedly to cycle through the modes of control. Some modes use the display counter to convey information. These modes, an...
7 troubleshooting if the equipment fails to operate after you have read the instructions, follow the suggestions listed below. If the problem persists, do not attempt to dismantle this product. There are no serviceable parts. Is powerlink receiving power? Does the wall outlet work with other devices...
8 8 maintenance care & cleaning routinely check powerlink before each use to confirm solid connection to ac power source. Do not use powerlink if any cord appears to be damaged. If the device becomes wet or does not work properly, unplug the device immediately and do not attempt to use. If cleaning ...
