Abode IP Streaming Camera User Manual - page 2
1. IP Camera Lens
2. Power LED (Green)
• On: powered
•Off: unpowered
3. WPS transmission LED (Red)
• Flashes for 5 seconds: Entering WPS protocol
• Flashes for 3 seconds: Connected to Wi-Fi
4. Internet-Connection LED (Blue)
• On: connected to internet(wired or wireless)
• Off: disconnected from internet
5. Speaker
6. WPS Button
(Press WPS button on Wi-Fi
router then press the camera WPS button)
7. Privacy Button
Press and hold for 2 seconds to enter or exit
privacy mode. Press and hold for 10 seconds to
enter pairing mode.
8. Expandable Micro-SD slot
9. Ethernet Cable Port
10. DC Jack(5V DC, 2A input)
11. Camera bracket mounting hole
12. Microphone
13. Photo Cell, turns on illumination for
low light, changes camera Color/BW
14. Near invisible infrared illumination LED’s
15. Camera mounting bracket
15
1
2
3
4
5
6
7
8
9
10
11
12
14
13
Indentifying the Components
Rocker switch
Preparing to pair the streaming camera to the abode gateway
1. Remove the camera, power transformer, and ethernet cable from the box
2. Plug one end of the ethernet cable into a spare port on your router, and the other end into the
back of the camera. (The ethernet cable is used to register your camera, add it to the gateway,
and, to set it up to communicate with your wireless Wi-Fi router.)
3. Insert the power transformer connector into the back of the camera and plug the transformer
into an AC outlet.
4. Next you will use your abode web or mobile app to pair the streaming camera with the gateway,
once this is accomplished you will be able to stream live video from the web and mobile app.
abode Systems Inc. Website: www.goabode.com 2015
abode reserves the right to update this product information at any time without notice.
Red and Green LEDS can be disabled using
web app settings (Future feature)
2